Axel Oxygen 5 User Manual download pdf (Page 19)

Oxygen 4 Digital - from Axel Technology Phone +39 051736555, support@axeltechnology.com Page 19

9 Hardware Connections

This chapter will describe all connections to the 19” rack unit in detail. After this chapter you have all

information to implement the system within your hardware. Some connections are software dependent

and can be configured by software. Chapter 11 will explain everything on this settings.

The Oxygen 4 Digital is equipped with Sub-D connectors. This way it is possible to have a lot of I/O in a small

space. The pinning is as follows for the female Sub-D connectors:

Figure 5: 9 pins female Sub-d

Each section of this chapter has a table which shows how the connectors are wired.

9.1 Analog In-/Outputs

On the Oxygen 4 Digital 19” rack you can find several different types of analog inputs. Below we will describe

every input type to give you an overview on the dedicated purpose of this input.

9.1.1 MIC inputs

Figure 6: Microphone inputs at front

You can see on the right side of the front panel the XLR connection for the microphones. Here you also

have the dedicated phantom power switches providing the MIC inputs with +48V phantom power.

Note: For maximum safety it's best to connect/disconnect the microphone(s) when the

console is powered off. This is also required for all the other in/outputs; Make sure you

ALWAYS switch off the phantom power before patching the microphones.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 71 72

No comments

Axel Oxygen 5 User Manual Page 19