Axel Oxygen 3 Operations Instructions download pdf (Page 32)

Oxygen 7Oxygen 7 - STEREO MODULE

Pag. 32

8.7 REMOTE interface

This 15P SUB D FEMALE connector allows you to implement the

following facilities:

• Remote Start for equipment connected to Input A

• Remote Stop for equipment connected to Input A

• Remote Start for equipment connected to Input B

• Remote Stop for equipment connected to Input B

• Remote PFL enable

• Remote Start/Stop control

The Connettors provides also +6VDC and GND conections.

Only one of the two Start commands (A or B) will be active at any time,

depending upon the setting of the B SEL switch (see)

Please refer to § 8.1 for interface connections.

8.8 MODULE OPTIONS AND JUMPER SETTINGS

The STEREO module can be configured in a number of different ways

depending on the jumper options set on the JUMPER SET area:

The remote Start and Stop commands for A Input can be made either

momentary or latched by setting the jumper A.REM. LATCH. When

jumper is closed, commands are latched and viceversa. The same option

(momentary or latched) is available also for Input B. The related

configuration jumper is situated on an internal, additional module board,

behind the Input B jack connector (ref to the picture here closed)

Input A is configurable for a nominal input level of –10 dBu, 0 dBu or + 4

dBu. Setting an input for –10 dBu, while connecting an audio source with

a +4dBu nominal level can lead to distortion (“clipping”) of the signal. To

remedy this problem simply use the appropriate jumper setting to

configure the input for +4dBu operation. Please, set Left and Right

channel at the same nominal input level. The second and third rows of

connector are referred to Input A left, while fourth and fifth rows are

referred to Input A Right.

When FADER ÙÙ START jumper is closed, moving the fader away from

the down position brings the module into the ON status and a Start

command is given (see Remote Interface). Moving the fader back to its

down position brings the module to OFF status. This jumper does not

affect START button operating.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 50 51

No comments

Axel Oxygen 3 Operations Instructions Page 32