Axel Oxygen 3 Operations Instructions download pdf (Page 35)

Oxygen 7Oxygen 7 - STEREO MODULE

Pag. 35

channel fader, and therefore follows any changes in fader level. It is

normally used to drive effects processing units which are fed back into the

mixer and which must fade out with the input channel.

The channels `START' switch will NOT switch the Auxiliary send on or off

when it is set post fader.

8.13 BALANCE

It adjusts the balance between the L and R outputs. At the detented centre

position the signal routes equally to L and R.

8.14 MASTER-SUB1-SUB2 ROUTING SWITCHES

The input channel signal may be routed to the main Stereo MIX (L-R) or

pairs SUB busses 1 & 2 by pressing the respective switches.

The routing switchers work in conjunction with the module status (On or

Off)

There is a red LED next to each switch which will illuminate at two levels

of brightness.

The LED will illuminate at half brightness if the Switch is pressed but the

module is Off.

You may regard this as the routing circuit being armed but not active.

To make it active the On status must be engaged (see § ). The LED will

illuminate at full brightness to indicate that the circuit is now active.

When one or more routing switchers are depressed, LED is off and the

routing circuit is never active, regardless of the module status (On/Off).

LED OFF

switch depressed / the status of the

module doesn’t affect routing circuit

LED ON

switch pressed / routing circuit is active as

the module is On

LED HALF BRIGH.

switch pressed / routing circuit is non

active as the module is Off

This three mode operating has been introduced in order to prevent buss

from additional noise when routing switchers are pressed and module is

off.

The Sub mix can be mixed into the main output mixbuss in the master

section (see Master routing switcher on the Sub modules).

This is a convenient way to use the SUB assigment switch as a su/jointfilesconvert/268126/bgroup

system, creating new possibilities in the Oxygen 7 console.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 50 51

No comments

Axel Oxygen 3 Operations Instructions Page 35